image of sustainability measurement heading

ThermoSense MK1


1.0 Introduction

2.0 Overview

3.0 Hardware

4.0 ThermoSoft MK1

5.0 How to Order

3.0 ThermoSense Mk1 Hardware

The ThermoSense Mk1 hardware has the Purchase Code IAI-TS-Mk1-HP


ThermoSense MK1 consists of the following items.

(a) Blue Snail USB to 1 wire/RJ11 driver ( DS 9490R) Code IAI-Snail -HP
image of Maxim's Blue Snail
(b) Red Cone Temperature Sensor ( uses Maxim DS 18B20) Code IAI-CS-R-202-P
Note: Each Red Cone is connected by a cable terminated by an RJ11 plug.
image of Red Cone

(c) Black Cone Temperature Sensor ( uses Maxim DS 18B20) Code IAI-CS-B-202-P
Note: Each Black Cone is connected by a cable terminated by an RJ11 plug.
image of black Cone

d) RJ11 Connector 1 to 2 expansion. Code IAI-RJ11-302-P
The Red Cone and Black Cones RJ11 connectors plug into this Device.
image of RJ11 Expansion Connector

This device plugs into the Blue Snail as shown (PS ---Sometimes the Snails are green!)
image of Blue snail in connection with Expansion Connector

The Following picture shows the hardware component parts all connected ready to just plug into a standard USB port. image of sensors connected to Blue Snail

Continue to next page

design: weboflife.bizCopyright © 2010 Imaging Associates. All Rights Reserved